Make Your Own Wood Lathe Chuck

TEKNATOOL SUPERNOVA 2 SUPERNOVA2 23245 Chuck Kit with JSCOLE jaws JS25N jaws JS100N jaws Woodworm Screw PLUS JS50N 2 jaws NCSC Chuck Spur 4mm Bondhus Hex Key for fast jaw changes Supernova 2 23245 Kit plus 2 Jaws Chuck Spur Bondhus 4mm Hex Key for Fast Jaw Changes Includes SN2 chuck JSCOLE jaws JS25N Jaws JS100N jaws Woodworm screw Fasteners PLUS JS50N 2 jaws NCSC Chuck spur Bonhus fast change hex key THIS IS AN ISERT TYPE CHUCK.

Make your own wood lathe chuck. I made a drill powered minipen lathe using roller blade wheel bearings and a couple of scrap pieces of plywoodFor futher information check out my insructab. I used my BigPrint program to print a 11 template of the main part of the chuck and cut it out of Baltic birch plywood. Woodworking - YouTube.

This needs to go in fairly precisely. A piece of threaded rod will go into each of the four slots. If youve got questions about the lathe ask it in the comment section.

With the chuck on the lathe turn the lathe on slowly and using a skew clean up any rough edges and remove any loose rubber. Videos you watch may be added to the TV. The only limit to the potential of home-made chucks is your imagination.

As I tend to turn about six or eight bowls in a row and then let the finish dry to later finish the bottoms I decided I needed or at least wanted a quick way to do the bottoms. When the caulk is dry it is time to mount it to the lathe and finish it up. Add Tip Ask Question Comment Download Step 2.

All you need is a faceplate. A screw chuck is a very old and very handy way to hold a lot of projects such as bowls and platters on a wood turning lathe. Wood Turning Bottom Jaws.

And a chuck to hold the work and 4 inches for the. The simplest home-made chuck is a waste block of wood glued to the bowl blank and used for holding. In This Instructables I Am Going to Share a Brilliant Idea About How to Make a Power DIY Mini Lathe.