How To Turn Sphere On Wood Lathe

Woodturners always want to turn a perfect sphere and they usually have their own method for doing this.

How to turn sphere on wood lathe. Turning a ball on a wood lathe is done using a parting tool to mark off where the ball will end and the ball should be formed from the center down to the sh. How To Turn A Sphere on the Lathe - WOOD magazine - YouTube. The Ghost method described below is more a technique for refining the shape of a sphere than turning one from scratch.

Rough-turn the Sphere. About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy Safety How. Begin by removing the excess wood at the corner of the cylinder.

After that I used a parting tool to turn the ends down to about 1 cm. Ad At Surplex you will find used machinery and industry equipment at best prices. If youre starting with rough wood use a roughing gouge to cut the wood down.

Orlandos Rob Hoppe provides a set of step-by-steps that will help you create wooden spheres. I like to start with a 34 shallow spindle gouge sharpened with a fingernail grind. You can use a template or follow one of the many recipes which are based on geometrical approximations.

How To Turn A Sphere on the Lathe - WOOD magazine. Online Reclaimed wood table. Take the ball off the lathe and put it on the drill press and drill a 1-14 diameter hole using a forstner bit in the spot where there was not enough wood.

A circle drawn on a piece of card stock is taped to the platform centered under the workpiece. Put a scrap piece of wood in the chuck on the lathe and turned down it down until it is a tight fit and used it as a plug for the hole. Checking it at a few different angles.