How To Make A Thin Parting Tool

The idea is to turn an old used sawzall blade into to tool make a handle of wood and used some epoxy and brass rod for rivets or whatever they are called in knive handles.

How to make a thin parting tool. Often enough to avoid having to face it off in a second op. BA DA Bing BA DA Boom. Second if the tip of the parting tool is ground at an angle it will minimize the nib further.

First setting proper tool height will minimize the nib. I rarely need a finish cut from a parting tool. When turning a bowl on the lathe and holding it by a tenon in a multi-jawed chuck the parting tool can be used to part the bowl from the lathe.

Eddies first video on making a parting tool was to start off by using a lawn edger blade and reshaping it with a grinder then he did a second video on using sawzall blades or reciprocal saw blades. Starting On Parting Tool. If I do I sharpen the tool and start the parting with the tool tip below center and the handle up.

It can be a bit intimidating at first but after some practice youll get the hang of it. This is using the tool as a negative rake scraper. Shape it a little on the disk sander and fine tune the cutting tip.

The cutting action can be scraping or bevel-rubbing depending upon the geometry of the tool. The double-bevel HSS cutting face imparts fine parting lines to turnings. These are intended primarily for making thin parting cuts to separate a piece from waste wood.

While the ultra-thin blade is only 116 wide approx the 1-14 blade height provides rigidity and stability when cutting. Being a contractor I just happen to have a box of old blades I can use for making my parting tool. Woodturning Parting Tool.