How To Clean Raw Wood After Sanding

The next step is the trick here.
How to clean raw wood after sanding. Use a soft-bristled brush to scrub down the surface. Wipe With Denatured Alcohol Many woodworkers end the wood preparation step with the tack-cloth wipe-down but for the very best results conclude your preparation by wiping down the surfaces with a clean cloth moistened with denatured alcohol. Modern Masters Exterior Dead Flat Varnish.
Wipe the surface thoroughly with a a wet cloth. Using denatured alcohol after sanding would work too. They are very handy if you need to de-grease anything.
It has been a woodworkers tool for a long time. On certain woods such as oak and ash pre-wet the wood with a damp cloth to raise the grain before final sanding. Then switch to fine sandpaper 200 grit until the entire piece is uniform.
Wipe down the whole surface with a tack cloth to remove any dust from sanding. You will need to use mineral spirits after sanding. By any chance if any oily substance sticks with the wood mineral spirits can help to remove it.
Always see to it that you will be sanding along the wood grain. The mineral spirit evaporates fast without posing any threat to the wood. The most important part of finishing a piece of furniture happens before you open a can of stain or paint it starts with the sanding.
While blowing the dust off with compressed air removes the dust it also mixes it into the air so some of it can settle back onto the surface and so you can breath it. Stir the contents of the can every time you open it. Allow the dampened wood to dry 30 minutes before the final sanding.