How Do I Clean Wood Before Painting

Dry off the wood with a clean dry microfiber cloth.
How do i clean wood before painting. Move on to the next section below that one. It was mentioned that you should clean wood furniture with solution and a cloth before painting. Wash wood from the bottom upward with slow easy up-and-down strokes so the solution has time to soften the grime.
Take the drawers out and wipe them with vinegar water as well. I think the wood is maple and Im not sure if it has a veneer or if it is solid. When all sections are done spray the entire house side once again.
Then use a vacuum or blower to get rid of dust from tricky spots. I typically fill a bucket with warm water and a few tablespoons of vinegar. Basically it gives you the cleaning power of the hardware store TSP without the yucky toxic stuff.
To avoid raising the wood grain wring out the cloth thoroughly before using it and wipe lightly. Use an oscillating tool fitted with a rigid edge blade then fitted with coarse grit sandpaper to peel away and then sand any pocked or loosened patches of paint or to remove caked on debris. Do I also need to strip the finish.
Steps to take for cleaning wood before staining is similar to painting. But there is no point whatever in cleaning bare wood with TSP or latex painted wood with TSP. Step 3 Sand out scuffs you cant wipe away using 120- or 150-grit -- or finer -- sandpaper.
Dont use paper towels as this will leave behind paper particles that may affect the staining of the wood in the future. Once you are done with that bring in tack cloth to give proper finishing to the cleaning procedure. Let dry by itself at least 24-48 hours before painting.