Can I Paint Right After Sanding

If you try to paint or stain rough wood it can be difficult to get the brush to evenly coat the surface.

Can i paint right after sanding. Preparing for paint is a very important step and depending on the relative humidity in the home ie. After painting something I typically like to wait at least a week so the paint is cured however this can depend on the paint thickness and your climate. A simple product that combines sand or similar abrasive material on the strong backing paper sandpaper is used to smooth surfaces remove rust or paint and can prepare a surface as well.

When finished with all of your sanding carefully wipe down and vacuum up all traces of dust and debris before you introduce primer and paint into the picture. No one wants that. And this is good news because sanding down wood surfaces is important if you want to achieve a smooth and even paint job.

Its been said that roller marks are just part of the process that you have to deal with when you take on a DIY painting project. While blowing the dust off with compressed air removes the dust it also mixes it into the air so some of it can settle back onto the surface and so you can breath it. If you are wet sanding a finished paint job you definitely do not want to start with a 400 grit sandpaper as it will be much too harsh and can ruin your paint finish instead of restoring it.

If you plan on just painting your wood you can stop at a 120 grit sandpaper. The grit of the sandpaper may range from coarse and rough to nearly smooth. You can paint over wood paneling without having to fear that it will peel off.

If you have a lot of residues stuck on your wooden piece you should re-apply paint stripper and scrape it off once again. During the winter months it could take up to a week for the drywall joint compound to properly cure. Drywall taping compound must be left to cure a minimum of 12 hours before sanding.

This means you may have to sand the finish down and start over. Actually sanding between coats of primer is pointless. The trick is using the right product and starting with the right primer.